Scripted HTML version of Foils prepared 27 August 1996

Foil 164 Why is it hard to use HPCC in Manufacturing-I?

From CPS615-Introduction-Course,Driving Technology and HPCC Current Status and Futures CPS615 Basic Simulation Track for Computational Science -- Fall Semester 96. by Geoffrey C. Fox *

Return on Investment Unclear:
  • Amdahl's law for use of HPCC in Industrial Simulation
    • If Simulation was only 10% or less of original design and manufacturing cycle, then can only gain this 10% by speeding up simulation
    • And this speedup comes at huge software engineering cost !
    • Codes are long and expertise to convert to parallelism may no longer exist in new "slim" companies after layoffs , buyouts and freeze on hiring new employees with knowledge of new technologies such as HPCC
    • New codes must be validated by extensive tests before use
    • Remember we can't solve full Navier-Stokes Equations yet and so some approximations necessary
The Industry is in a very competitive situation and focussed on short term needs



© Northeast Parallel Architectures Center, Syracuse University, npac@npac.syr.edu

If you have any comments about this server, send e-mail to webmaster@npac.syr.edu.

Page produced by wwwfoil on Wed Aug 27 1997